Safety instructions T26 DC/AC, T32 DC/AC
6
z Do not pull the plug out of the cigarette lighter or the socket by
the cable.
z If the connection cable is damaged, it must be replaced to pre-
vent possible electrical hazards. This can only be repaired by an
authorised customer services unit.
z Pull out the connection cable:
– Before cleaning and maintenance
– After use
z On boats: if the device is powered by the mains, ensure that the
power supply has a ground fault interrupter circuit. Danger of
fatal injuries!
z Disconnect the cooling device and other power consuming
devices from the battery before connecting the quick charging
device.
z Check that the voltage specification on the type plate corre-
sponds to that of the energy supply.
1.2 Operating the device safely
z Before starting the device, ensure that the power supply cable
and the plug are dry.
z Do not place the device near naked flames or other heat
sources (heaters, direct sunlight, gas ovens etc.)
z Caution! Danger of overheating!
Ensure at all times that there is sufficient ventilation so that the
heat that arises during operation does not build up. Make sure
that the device is sufficiently far away from walls and other
objects so that the air can circulate.
z Do not fill the inner container with ice or fluid.
z Never immerse the device in water.
z Protect the device and the cable against heat and moisture.
z Do not touch exposed cables with your bare hands. This
especially applies when operating the device with an AC mains
power supply. Danger of fatal injuries!
z The manufacturer cannot be held liable for damage resulting
from improper usage or incorrect operation.
T26_32_DC-AC.book Seite 6 Freitag, 14. März 2008 3:19 15
To Next Page
Loading...
Need help?
General
