Six Common Rules For All Users:
1. The AC adapter supplied is designed for dry indoor use only. DO NOT use
the AC adapter outdoors or in wet conditions.
2. Make sure the supplied antenna is connected at all times when transmitter
unit is powered ON. This will prevent damage to your unit.
3. For best results try to find an open (unused) frequency to transmit on. Do
not transmit on occupied commercial radio station frequency; for legal and
ethical reasons.
4. Always follow your local regulations regarding the proper use of an FM
transmitter. If you are not aware of local regulations that may apply to you;
you should therefore set transmit power to no more than 5mW.
5. Only use power adapters supplied with your unit. Using other types of
power adapters may produce background noise with your transmitted
audio and/or could damage your unit.
6. When transmitting from a microphone; only use a stereo plug microphone,
using any other type of microphone such as a mono plug microphone will
permanently damage your unit, see “Operating Instructions - step #4”
1. Connect antenna to antenna port . (DO NOT operate transmitter without
antenna connected, damage may occur to the unit.)
2. Connect power source to DC power input jack , using the supplied USB/DC power
cord. Unit may be powered via supplied AC adapter or car adapter or USB port
(PC/MAC) or two AAA batteries.
3. Connect audio source using supplied 3.5mm audio cable. Connect one end to Audio
input jack . Connect the other end of the cable to audio output jack (or headphone
jack) of the source device ie. MP3 player, iPod, PC, MAC, PDA, DVD player, etc.
4. Optional – transmitting from a microphone: You may transmit audio from a
microphone by connecting a stereo plug-type microphone to the microphone input jack
.
(DO NOT USE A MONO PLUG-TYPE MICROPHONE, DOING SO WILL CAUSE
PERMANENT DAMAGE TO YOUR V6000 UNIT) see illustration below….
To Next Page