CHARGING INSTRUCTIONS:
CAUTIONS
Prior to charge this device, read and understand all the related instruction indicated below.
Fully charge the unit after each use or every 6 months. This product may arrive partially
charged from the factory. It is highly recommended to fully charge the LIGHTBOLT unit after
purchase and before using it for the first time.
Make certain that all ON/OFF Power Switches are set in the OFF position.
Do not charge the LIGHTBOLT near flammable material, open flame or any
location which accumulate flammable fumes.
Make certain the electrical outlet located in a potentially wet or moist area that is to be used
to charge this device, is protected by a Ground Fault Circuit Interrupter (GFCI).
A. AC Charging At Home with 110 Volt AC Charging Adaptor:
1. Make certain the Spotlight ON/OFF Button is in OFF position and the Worklight retracted fully all the
way down in OFF position while charging.
3. Connect the AC Charging Plug at the of cable, into the Input Charging Port of the LightBolt unit.
4. Connect the AC Charging Adaptor into the 110 Volt AC home receptacle. The LED near the Input
Charging Port illuminates RED indicating the internal battery is being charged.
5. Fully charge the LightBolt according to the following schedules:
First time charge: 6 hours or when the RED LED charge indicator turns GREEN.
Recharge and subsequent charge: 3 hours or when the RED LED charge indicator turns GREEN.
6. Unplug the AC Charging Adaptor from 110 Volt receptacle first and then remove the Plug from the
LightBolt Input Charging Port.
B. DC Charging In Your Vehicle with 12 Volt DC Charging Adaptor:
1. Make certain the Spotlight ON/OFF Button is in OFF position and the Worklight retracted fully all the
way down in OFF position while charging.
3. Connect the DC Charging Plug at the of cable, into the Input Charging Port of the LightBolt unit.
4. Connect the DC Charging Adaptor into a Vehicle 12V DC or cigarette lighter socket. The LED near
the Input Charging Port illuminates RED indicating the internal battery is being charged.
5. Fully charge the LightBolt for 2 1/2 hours or when the RED LED charge indicator turns GREEN.
6. Unplug the DC Charging Adaptor from the 12V Vehicle DC socket first and then remove the Plug
from the LightBolt Input Charging Port.
Sheet 4 of 8
Model No. 4030
To Next Page
Loading...