NOTE: If the vehicle fails to start, reconnect the dual 12 Volt DC plug Booster Cable to the
vehicle and the Power 400 12 Volt DC port. Allow an additional 20 minutes for boost charge
before attempting to restart vehicle again.
110 Volt AC Household Electronic Devices
Powered by Power 400 built-in 400 Watt inverter
Electronics Device Power Consumption Approximate Operating time
Small Utility light 2 Watt 35 Hours and 40 Minutes
iPhone/iPod/MP3 4 Watt 17 Hours and 50 Minutes
Cell Phone Chargers 5 Watt 17 Hours and 30 Minutes
Radios 8 Watt 9 Hours
Fans 20 Watt 3 Hours and 30 Minutes
Power tool chargers 25 Watt 3 Hours
Up to 10Volt
Digital/Video Camera 30 Watt 2 Hours and 30 Minutes
9” portable TV 50 Watt 1 Hours and 50 Minutes
IMPORTANT NOTE: The above listing is prepared for reference purposes ONLY. Certain electronic de-
vices exceed the power consumption wattage listed. Prior to powering the intended electronic devices,
refer to and review the Instruction Manual for actual wattage requirement.
USB OUTPUT PORT:
1. Prior to connecting the device to be powered to the USB port, make sure the USB power switch is
in OFF position. The power switch must be positioned in the middle.
2. Prior to plug in the device to the USB port, make sure the device power switch is OFF position.
3. Using the USB cable included with your electronic device to be powered or charged, connect the
USB plug into the USB port of Power 400.
4. Connect the other end of the cable to the into the electronic device.
5. Press the USB port Power Switch to ON (—) position. The device with built in rechargeable battery
will start charging automatically. Turn ON the electronic device and use as normal after charging.
6. After using the USB port, the USB Power Switch must be turned to OFF (O) position, Otherwise the
7. internal battery of Power 400 will be slowly depleted, although there is no electronic device attached
to the USB port.
8. Turn OFF the electronic device and disconnect the cable from the USB port.
VEHICLE JUMP START INSTRUCTIONS:
WARNINGS: Vehicles equipped with on-board computers may be damaged if the vehicle is jump
started. Review and understand your vehicle owner’s manual instructions before attempting to
jump-start your vehicle. Failure to follow these advisory instructions my result in personal injury
and property damage. Use Safety Glasses to protect your eyes while working near battery during
jump-staring a vehicle. Jump start a vehicle in an open area without any type of obstructions.
CAUTIONS: Make certain that the Power 400 Main Booster Power Switch is in OFF position
before starting to jump start a vehicle.
1. Turn off the vehicle ignition and all the accessories (Such as radios, lights, and air conditioners,
etc.).
2. Apply the emergency brake and put those vehicles with automatic transmission in park position.
3. Determine the polarity of the vehicle battery terminals. The positive (+) battery terminal normally
is larger in diameter than the negative (-) terminal. If you are unsure, you must refer to the
vehicle owner’s manual.
Model No. 2001
Sheet 7 of 12
To Next Page