Federal Communication Commission
Interference Statement
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates
uses and can radiate radio frequency energy and,
if not installed and used in accordance with the
instructions, may cause harmful interference to
radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning
the equipment off and on, the user is encouraged
to try to correct the interference by one of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment
and receiver.
- Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/ TV
technician for help.
FCC Caution: Any changes or modifications not
expressly approved by the party responsible for
compliance could void the user's authority to
operate this equipment.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
This equipment complies with FCC RF radiation
exposure limits set forth for an uncontrolled
environment. To maintain compliance with FCC
RF exposure compliance requirements, please
avoid direct contact to the transmitting antenna
during transmitting
RF Exposure Warning!
Please keep product 20cm away from your body
or bystander during the radio operation. The
typical handheld two-way radios were certified
under mobile usage condition
(i.e. keep 20cm away from the user body) and
use of such radio closer than 20cm may exceed
the US RF exposure limit and shall be avoided.
PTT- Z or PTT-U
PUSH-TO-TALK Specification
PTT-U2
PTT-Z PTT-U1
PTT-U3
Mobility Sound PTT- Z
Model No.: PTT- Z or PTT-U
Made in Taiwan
All other product or service names are the
property of their respective
owners.
© 2014 Mobility Sound Technology Ltd,,
All Rights
Reserved
To Next Page
Need help?
General