12
3.
Connect the gas hose to the stove and regulator by following the
steps specified in Picture 2, and secure both connections using hose
clamp.
4.
To ensure the safety, hook the attached chain
to the wall and make sure the hook is
firmly attached to the wall. (For series
with hook provided)
After the gas hose is properly installed, perform gas leakage test on the
oven connector as follows
1.
Connect the regulator with gas cylinder
2.
Smear soap water (soap mixed with water) on the connection.
3.
Observe the connection. Bubbles formed on the surface indicates
that gas pressure is leaking out of the connection.
ATTENTION
• Use standardized hose for gas stove equipped with leak safety
equipments.
• Use proper hose and regulator to avoid gas leak which may
result in explosion.
• Do not use high pressure gas regulator
To Next Page
Loading...
