English 14
PRECAUTIONS FOR INSTALLATION
WARNING
Installation should be performed only by the dealer or a qualified expert. Attempting to install the unit
yourself could result in water leakeage, refrigerant leakage,electrical shock, or fire.
Install the Showcase Cooler on even and
sturdy surface. Uneven surface may cause
objects in it to fall.
Provide adequate space for air circulation
between the Showcase Cooler and the wall
to minimize the operational costs and to
maximize the compressor’s age.
Do not put the Showcase Cooler near the
heat source such as stove, hot plates etc.
And avoid placing unit
under direct sunlight which may hamper with
the cooling process.
Do not use the unit in an open location,
keep it away from sunlight and exposed to
rain water. Using Showcase Cooler which
has been exposed to rainwater will result in
electricity leakage.
Make sure the voltage is set to 220 volt
and the frequency to 50 Hz. Do not use
cord extension or branched outlet since it
poses risks of shortage, overheating and fire.
If the unit must be installed in a humid
environment, make sure to install a circuit
breaker to avoid shortage.
To Next Page
Loading...
