7
Installation Preparation
⚫ The installation position of dishwasher should be placed near the existing water
inlet tap and drain outlet and power socket.
⚫ One side of the sink cabinet should be chosen to facilitate the connection of
drain hoses of the dishwasher.
Positioning the Appliance
⚫ Position the appliance in the desired location. The back should stick to the wall
behind it, and the sides to the adjacent cabinets or wall. The dishwasher is
equipped with water inlet hose and drain hoses that can be positioned to the
right or the left to facilitate proper installation.
Power Connection
Electrical requirements:
Please look at the rating label to know the rating voltage and connect the dishwasher
to the appropriate power supply. Use the required fuse 10 amp, time delay fuse or
recommended circuit breaker and provide separate circuit for this appliance only.
Electrical connection:
Ensure the voltage and frequency of the power source match with the rating plate.
Only insert the plug into an electrical socket which is properly grounded. If the
electrical socket is not suitable with the appliance’s plug, replace the socket, rather
than using an adapter as it could cause overheating and risk of fire.
Ensure that the grounding is proper before using the dishwasher!
WARNING!
For personal safety:
⚫ DO NOT use an extension cord or an adapter plug for this appliance
⚫ DO NOT under any circumstances, cut or remove the grounding
connection from the power cord
To Next Page
Loading...
