English 21
Before placing the unit, follow the instructions and the instructions below for the correct and safe
placement.
Install the freezer on even and sturdy surface.
Uneven surface may cause objects in it to fall.
Provide adequate space for air circulation
between the freezer and the wall to minimize
the operational costs and to maximize the
compressor’s age.
Do not put the wine cellar near the heat source
such as stove, hot plates etc. And avoid
placing wine cellar under direct sunlight which
may hamper with the cooling process.
Do not expose the wine cellar to rain water.
Using wine cellar which has been exposed to
rainwater will result in electricity leakage.
Make sure the voltage is set to 220 volt and the
frequency to 50 Hz. Do not use cord extension
or branched outlet since it poses risks of
shortage, overheating and fire.
If the unit must be installed in a humid
environment, make sure to install a circuit
breaker to avoid shortage
BEFORE INSTALLATION AND CONNECTING THE RESOURCES
To avoid fire, electric shock or leakage:
1. Never place the unit in a room whose floor is wet, watery, or in a place where the water is
stagnant.
2. Check the things below before you connect the unit to the power source:
- Connect the power cord into an outlet that is equipped with grounding.
- Do not plug the power cord units with other equipment on the same outlet.
3. Do not let the power cord pinched by heavy objects.
- If you hear a strange noise or strong chemical odor or smoke, etc. are of the unit after you
connect the power source, unplug immediately and contact the service center.
- Before connecting the unit to a power source, let it stand upright for approximately 2 hours. This
will reduce the possibility of damage to the cooling system from handling during transportation.
To Next Page
Loading...