English 23
When the installation is ready, make sure that the power supply has fuse whose specification is 15A,
220V, 50 Hz. When the heating function is used, maximum current of washing machine is 10A. Make
sure the power supply (current, voltage, and cable) fills the requirement to operate this appliance on
normal load.
- Washing maching must be grounded so that when there is problem, current can be conducted to
ground, minimize the risk of short circuit. If you are not sure if the washing machine has been
grounded well or not, you can contact the experienced technician.
- The pressure of supply water is between 50kPa until 800kPa for the normal operation of washing
machine. If the water supply is too low, the input water valve may not work normally or the
washing time becomes longer and display will show error code ”SF”.
- Check all connection on input water supply, valve, and faucet to avoid the water leakage.
- The result of the washing machine depends on the effectivity of the detergent used. The dirt on
the clothes may not be able to be vanished by using bad quality detergent. Please clean the dirt
on the clothes like explained by this book before being washed by washing machine.
Open the washing machine from the box and put it on flat and strong floor. Don’t place the washing
machine on not flat or sloping floor, above carpet or on above wooden floor. Don’t place the washing
machine outdoor, and avoid humid place that can evoke defect.
1. Loosen all bolts behind the washing machine
- For transportation purpose , this washing machine is locked
with added polyfoam. Before operating the washing
machine, loosen all bolts like rightside picture.
- Fill the holes with supplied covers at the
rear of enclosure.
- Keep the polyfoam and bolts for transportation purpose and
use it again before transporting the washing machine..
Part 3 : First Step Before Installation
To Next Page
Loading...
