Modern Forms F-RCBT-WT User Manual

OPERATION INSTRUCTIONS
F-RCBT-WT
Package Contents
Pairing
To pair your remote control:
1. Power cycle your fan by removing power from the circuit
breaker for 10 seconds and then re-enable power.
2. Press and hold and buttons on remote control
for 4-5 seconds.
3. The LED will blink green.
4. The green LED along with audible beeps will indicate that
pairing is successful.
5. Test remote control using the steps in section 2.
1
button: Switch between Summer and Winter Mode.
SUMMER MODE (Counter-Clockwise):
A downward airow creates a cooling
eect (FIG. 3). This allows you to set
your air conditioner on a warmer
setting without aecting your comfort.
WINTER MODE (Clockwise):
An upward airow moves
warm air o the ceiling area and
re-distributes the warm air that hovers
around the ceiling to the living space.
This should allow for savings on
heating costs (FIG. 4).
NOTE: On your fan, press the button while the fan is running
Remote Control Operation
Remote Control Button Functions
button: Turns the light ON or OFF.
Press or hold to increase the light level.
Press or hold to decrease the light level.
button: Turns the fan ON or OFF.
Press or hold the button to increase fan speed.
Press or hold the button to decrease fan speed.
2
BatteriesRemote Wall Cradle
Screws
CR2032
CR2032
Press and Hold
NOTE: A maximum of 10 remote controls or wall
controls can be used with a fan.
NOTE: Pairing must be completed within three (3) minutes of
turning the power ON to the fan receiever.
FIG.1
FIG.2
FIG.3
FIG.4
3
Breeze Mode
1. Breeze Mode mimics the natural ebb and ow
of winds in nature by varying the fan speed.
NOTE: Breeze Mode always rotates your fan
in the Summer (CCW) direction
2. To start Breeze Mode, press and
for 4 seconds. The LED will blink green
and the fan will beep.
3. To exit Breeze Mode and return to standard
fan mode, press and for 4 seconds.
The led will blink green and the fan will beep.
Your fan will return to the direction and speed
it was set to prior to entering Breeze Mode.
NOTE: Your fan features 6 speeds. An audible tone will
indicate when the speed is increased or decreased. When
the fan has reached the minimum/maximum speed level
the fan will beep twice.

Modern Forms F-RCBT-WT Specifications

General

Brand	Modern Forms
Model	F-RCBT-WT
Category	Fan
Language	English

Summary

Remote Pairing

Pairing Remote Control

Steps to pair the remote control with the fan receiver within 3 minutes of power restoration.

Remote Control Operation

Remote Button Functions

Description of button actions for light and fan speed control on the remote.

Breeze Mode Operation

Breeze Mode Activation

How to start and exit the natural wind simulation mode by pressing remote buttons.

Remote Unpairing

Unpairing Remote Control

Procedure to unpair the remote control from the fan receiver using button presses.

Wi-Fi Reset Function

Resetting Fan Wi-Fi Settings

Instructions to reset the fan's Wi-Fi settings for network reconfiguration.

Factory Reset Procedures

Remote Control Factory Reset

Factory reset using the remote control buttons, removing all paired devices.

Receiver Button Factory Reset

Factory reset performed directly on the fan receiver unit via its reset button.

Power Switch Factory Reset

Alternate factory reset method using the fan's power switch and cycling power.