Modern Lights LumaNumbers User Manual

Details product variety in sizes, colors, and mounting options for exterior installation.

Lists essential tools including drill, marker, level, tape measure, and screwdriver.

Instructions for carefully unboxing numbers and laying them out on a cloth to prevent scratches.

Details standard hardware, anchor bolts, and the two types of mounting risers (1/2 inch and 1/4 inch).

Describes the mounting plate, its screws, caps, and paintable off-white finish.

Explains mounting screws for the plate and threaded shafts for direct wall installation.

Guides on leveling templates and marking holes for direct wall or mounting plate installation.

Instructions on using a 3/16th drill bit for screw and wiring holes, emphasizing safety.

Steps to level and mark holes for mounting the plate itself to the wall.

Instructions for inserting screws through the mounting plate into the back of each number.

Explains installing 1/2 or 1/4 inch risers for different light spread effects.

Details on screwing threaded shafts into numbers for direct wall mounting.

Guidance on feeding wires through drilled holes without damage.

Gently threading and tightening screws from the plate's backside into the numbers.

Instructions for cutting, stripping, and twisting gray and white wires for power connection.

Using a heat gun to seal and solder wire connections for secure electrical contact.

Guides on connecting gray wires to +12V DC and white wires to -12V DC.

Mounting the plate with screws, mentioning the need for optional wall anchors.

Placing plastic caps over screw holes for a clean appearance.