Modern Predator - Page 35

3520’ Predator
Constant Velocity (CV) Driveline
)RUFXWWHUVHTXLSSHGZLWKD&RQVWDQW9HORFLW\&9GULYHOLQHWKHPD[LPXPWXUQLQJDQJOHEHWZHHQ
the tractor and cutter must be determined to ensure the joint angle does not over-extend which
can cause CV joint damage. Constant Velocity joints enable the driveline to operate smoothly with
no vibrations and clattering at angles up to 70°. Angles greater than 80° can result in mechanical
damage to the CV joint and cutter driveline.
7KH &RQVWDQW 9HORFLW\ MRLQW PXVW EH OXEULFDWHG HYHU\  KRXUV RI RSHUDWLRQ DV VSHFLÀHG LQ WKH
Maintenance Section. Failure to properly lubricate the joint will result in accelerated wear and joint
component failure.
CV Driveline Maximum Angle Check Procedure
• With the cutter attached to the tractor and the driveline disconnected from the tractor PTO
 VWXEPDNHDKDUGOHIWWXUQXQWLOWKHUHLVDSSUR[LPDWHO\DµFOHDUDQFHEHWZHHQWKHOHIWUHDU
tractor tire and cutter frame or tongue.
 6WRSDQGFRPSOHWHO\VKXWGRZQWKHWUDFWRU3ODFHWKHWUDFWRULQ3DUNDQGDSSO\WKH3DUNLQJ
 %UDNHEHIRUHGLVPRXQWLQJ
 &KHFNWKH&9MRLQWDWWKLVPD[LPXPWXUQLQJUDGLXVE\KROGLQJWKHGULYHOLQH\RNHDERYHWKH
PTO shaft andthen angle the CV joint to its maximum angle. A minimum difference of 10
 GHJUHHVEHWZHHQWKHFHQWHUOLQHRIWKH\RNHDQGWKH372VKDIWPXVWEHPDLQWDLQHGWRHQ
sure the joint will not be over angled. If the joint cannot be angled at least 10°, there is a po
 WHQWLDOSUREOHPRIRYHUDQJOLQJWKHMRLQWZKLOHPDNLQJVKDUSWXUQV
 6ROXWLRQV7RHQVXUHWKHMRLQWLVQRWGDPDJHGFKHFNWKHIROORZLQJ
&KHFNWKHGUDZEDUOHQJWKWRHQVXUHWKDWLWLVDWWKHSURSHUOHQJWKIRUWKH530VSHHGRIWKH
cutter.
Move the tractor rear tires wider apart to limit the tractor turning radius.
Position the cutter at multiple angles and perform the above procedure. Determine the sharpest
turning radius that maintains a safe operating angle and note this position to the operator.
OPERATION