EasyManua.ls Logo

Modernum smart 50 User Manual

Default Icon
6 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
USER GUIDE
Battery Charger
Smart
50
with built-in flashlight
for 6 – 200Ah lead-acid batteries
Please read this user guide carefully before using the charger
Use protective eyewear when handling batteries
INTRODUCTION
Thank you for choosing a professional quality product from
MODERNUM! This advanced and user-friendly battery charger
will optimize performance and lifetime of your battery.
This intelligent and fully automatic charger can be used to
charge any type of lead-acid batteries, including AGM and GEL
types from 6 to 200Ah. It has a flashlight that automatically
turns on while not connected to the battery.
Visit www.modernum.se for more info about us.
SAFETY
This charger is made for charging 12V lead-acid
batteries. Do not use it for other purposes or with other
battery types.
Do not try to recharge non-rechargeable batteries.
Do not use the charger if its casing, terminals, clamps or
cables are damaged.
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
Use protective eyewear when handling batteries, and
connecting or disconnecting it.
Battery acid is corrosive. If it comes in contact with skin
or eyes – rinse with plenty of water and contact a doctor
immediately.
During charge, a battery can emit explosive gases. Make
sure there are not sparks or flames close to it, and
ensure good ventilation.
Never charge a battery that is frozen.
Do not place the charger on top of the battery.
Do not cover the charger.
The charger is protected against overheating. If the
ambient temperature is too high, the charging current is
reduced.
During the charge, the charger may intermittently
provide a 15.0V charge voltage. Ensure that no
Question and Answer IconNeed help?

Do you have a question about the Modernum smart 50 and is the answer not in the manual?

Modernum smart 50 Specifications

Power IconPower
input voltage220-240 VAC
input current0.7A
charging voltage13.7 – 15.5VDC
Battery Specifications IconBattery Specifications
battery capacity6 – 200Ah
charging currentMax 5A
ripple voltageMax 70mV
Operating Environment IconOperating Environment
ambient temperature- 40 – +50°C
coolingConvection
international protection classIP54
Weight and Dimensions IconWeight and Dimensions
weight0.5 kg
dimensions230x40x38 mm
battery DC cable length1500 mm

Summary

Introduction

Safety Precautions

Getting Started

Instructions for Use

Special Features

Faults Indications & Trouble-Shooting

Lamp+Red Light Fault

Fault indicated by constant red light and lamp, suggesting reversed polarity or incorrect clamp connection to the battery.

No Charging / Flashlight On Fault

Fault where charging doesn't start and flashlight stays on, possibly due to poor clamp connection or low battery voltage.

Maintenance

Accessories

Technical Specifications

CE Manufacturer Declaration

Limited Warranty