3.6. Tyres
The tyres are subjected to inevitable wear due to friction. You can reduce the tyre wear by ensuring optimal air pressure and refraining
from locking the tyres when braking (skidding). You will need to replace your tyres if the rubber tread is worn down, or if the tyres have
become porous due to ageing and frequent exposure to the sun. The above sections explain how to change the tyres.
18
MAINTENANCE
Step 1. Guide the belt onto the pulley and
carefully fit the rear wheel in the dropout.
Step 3. Tighten the MOD Axle Nut using
the MOD Axle Nut tool and 16mm span-
ner provided in the tool box to 35-40Nm.
Step 2. Carefully mount the wheel to the
dropout and align the brake rotor inside
of the front brake. If necessary, loosen the
MOD Axle Nut to make this step easier.
FITTING
To Next Page
Loading...