Seite 5
2.2.4 PWM-Frequency (♪ ♪ ♪ ♪ )
PWM switching rate setting: Move stick into full back position
(1) ♪ 8kHz (2) ♪ ♪ 9kH (3) ♪ ♪ ♪ 10kHz
(4) ♪ ♪ ♪ ♪ 11kHz (5) ♪ ♪ ♪ ♪ ♪ 12kHz (6) ♪ ♪ ♪ ♪ ♪ ♪ 13kHz
(7)♪ ♪ ♪ ♪ ♪ ♪ ♪ 14kHz (8)♪ ♪ ♪ ♪ ♪ ♪ ♪ ♪ 15kHz (9) ♪ ♪ ♪ ♪ ♪ ♪ ♪ ♪ ♪ 16kHz
Move the stick to full power to select the desired setting (beeps counting) in the submenu.
Acknowledgement: ♪ ♪, the setting was saved.
2.2.5 Governor Mode (♪ ♪ ♪ ♪ ♪ )
Move stick into full back position,
♪ Governor mode OFF
♪♪ Governor mode ON
Move the stick to full power after the hearing the desired beeps. Acknowledgement: , the
setting was saved.
After setting of the speed regulation, the ESC will learn-in the operating speed at the
next start. It is therefore important to wait until you can notice a small speed jump
indicating that the regulation is activated.
If no selection has been made, the above menu options will start over again until a selection
is made.
Note:
The beep starts always with the current setting. This gives a way to sent a feedback to the
ESC settings.
After the setting of any of these parameters, moving the stick back to full back position will
arm the ESC. Alternatively the ESC can be disconnected and reconnected to allow the
setting of other parameters.
To Previous Page
Loading...
Need help?
General