Seite 4
In the advanced setup only ONE Menu option can be selected, therefore the main
menu choice must take place first:
Place the stick again into full back position to select the main meun to modify:
Main Menu Options overview:
♪ Brake ♪ ♪ Battery-Type ♪ ♪ ♪ Timing
♪ ♪ ♪ ♪ PWM-Frequency ♪ ♪ ♪ ♪ ♪ Governor mode
Move the stick to full power after hearing the sounds for the desired parameter.
Acknowledgement: ♪ ♪
Note: If any parameter has not be selected, the menu will begin again with “Brake” and so
on; If selected, depending upon the selection now the ESC switches to the setting of the
Parameter. Possible (sub) menus:
2.2.1 Brake (♪)
Brake selection
(Brake):
Move stick into full back position again
♪ No Brake
♪♪ Brake, Brake is activated if stick range has been configured accordingly.
Move the stick to full power to select the desired setting in the submenu.
Acknowledgement: ♪ ♪
After the acknowledgement the menu option is programmed!
If the stick is took back to full back position, the ESC is armed and ready for working
after the ready signal sounds was heard. This applies to each programming step.
If no selection is made, the above selection menus start over again until a selection is made.
2.2.2 Battery-Type (♪♪)
Battery selection (Battery-Type):
Move stick into full back position again:
♪ NiMh
♪♪ Auto
♪ ♪ ♪ Reserved
Move the stick to full power to select the desired setting in the submenu after hearing the
beeps for desired parameter. Acknowledgement: ♪♪ ,Setting is done.
2.2.3 Timing (♪♪♪)
Timing setting:
Move the stick into full back position:
The ESC starts with a single beep (30°) and processed up successively to 7 beeps (Auto
Timing). Example: To set 18°: Move the stick to full power to at the third beeps signal.
30° ♪ 24° ♪ ♪ 18° ♪ ♪ ♪ 12° ♪ ♪ ♪ ♪
6° ♪ ♪ ♪ ♪ ♪ 0° ♪ ♪ ♪ ♪ ♪ ♪ Autotiming ♪ ♪ ♪ ♪ ♪ ♪ ♪
Move the stick to full power after selecting the desired setting sounds.
Acknowledgement: ♪ ♪. The selection is finished
To Next Page
Loading...
Need help?
General