User Manual MODSTER M750
8 www.modster.at
Functions of MODSTER M750 e-Scooter & Safety Notice
Operation description
Please read this manual carefully before using the MODSTER M750 e-Scooter.
- Assemble the MODSTER M750 e-Scooter correctly and fully charge the battery before using.
- Before driving the user should be familiar with the driving environment
- Please do not wear any sharp objects to avoid injury during driving.
- Please do not drive on wet and slippery ground
Assembling the MODSTER M750 e-Scooter
Step 1: Take the MODSTER M750 e-Scooter frame and parts out of the package.
Step 2: Assemble the electric bicycle
1. Let the power wire located at the lower telescopic rod go through the upper telescopic rod.
2. Press the metal marble until it is on one level with the groove and put the two rods together.
3. Connect the handlbar's power wire with the power wire inside the telescopic rod.
4. Insert the handlebar into the upper telescopic rod and tighten the six screws before securing the clamp.
5. Put the saddle on its place and tighten four screws.
6. Install the pedals and tighten four screws before unfolding the pedals.
7. Unfold the bicycle body.
To Next Page
Loading...
Need help?
General
