Installation
01/02 AWB8230-1413GB
32
Connecting the supply voltage
X Connect the supply voltage to the power terminals L1, L2, L3
and PE:
Connecting external supply voltage for the control
electronics
If you also want to parameterize the DF6 frequency inverter with
the power supply switched off, connect an external power supply
(400 V ~) to terminals R0 and T0. Proceed as follows:
Table 6: Tightening torques and conductor cross-sections of terminals R0,T0
Figure 21: Cable connection to the power terminals
PES
R0, T0
mm
2
AWG mm Nm
DF6-340-... 1.5 to 2.5 16 to 14 8 to 10 9 M4 1.2 to 1.38 1
w
efesotomasyon.com - Klockner Moeller - inverter
To Next Page
Loading...