Moen 82009 - Supply Line Installation Steps; Valve Positioning and Flow Director Removal; Valve Rotation and Flow Director Installation

4
E
1A
SUPPLY LINES FROM ABOVE VALVE
SUPPLY LINES FROM ABOVE VALVE
SUPPLY LINES FROM ABOVE VALVE
2
D
1
2A
E
3A
D
1
2
Position the valve as seen in 1b. Locate and remove the Flow Director (D)
in the top outlet of the valve using a at head screwdriver.
Position the valve as seen in 1b. Locate and remove the Flow Director (D)
in the top outlet of the valve using a at head screwdriver.
Position the valve as seen in 1b. Locate and remove the Flow Director (D)
in the top outlet of the valve using a at head screwdriver.
Rotate the valve over as seen in 2b.
Rotate the valve over as seen in 2b.
Rotate the valve over as seen in 2b.
Install the Flow Director (D) into the valve as shown.
Install the Flow Director (D) into the valve as shown.
Install the Flow Director (D) into the valve as shown.
Supply Lines From Above Valve / Supply Lines From Above Valve / Supply Lines From Above Valve