Operating
Instructions
Safety InstructionsCare and Cleaning
Installation
Instructions
Troubleshooting Tips
Consumer Support
28
Care and cleaning of the range.
Painted surfaces include the sides of the
range and the sides of the door trim.
To clean the painted surfaces, use a hot,
damp cloth with a mild detergent suitable
for these surfaces. Use a clean, hot, damp
cloth to remove soap. Dry with a dry, clean
cloth.
Do not use steel-wood pads, commercial
oven cleaners, cleaning powders or other
abrasive cleaners. They will damage the
surface.
Painted Surfaces (on some models)
On glass cooktop models, the oven is vented
through an opening at the rear of the
cooktop.
On coil cooktop models, the oven is vented
through an opening under the right rear
surface unit.
Never cover the opening with aluminum foil or
any other material.
Oven Vent
To clean the outside glass finish, use a glass
cleaner. Rinse and polish with a dry cloth.
Glass Window (on some models)
Do not use a steel-wool pad; it will scratch the
surface.
Shake bottle well.
Place a small amount of Stainless Steel
Appliance Cleaner on a damp cloth or
damp paper towel.
Clean a small area (approximately
8″ x 8″), rubbing with the grain of the
stainless steel if applicable.
Dry and buff with a clean, dry paper
towel or soft cloth.
Repeat as necessary.
To inquire about purchasing Stainless Steel
Appliance Cleaner, or to find the location of
a dealer or Camco Parts Store nearest you,
please call our toll-free number:
National Parts Center 1-800-661-1616
Stainless Steel Surfaces (on some models)
To Next Page
Loading...
