Moffat Washing machine - Troubleshooting Common Issues (Continued); Stains and Residue Issues; Washing Time and Softener Rinsing Issues

162971
* UKS: universal stability control - this function prevents excessive vibrations during spinning.
26
Failure
Possible cause
Remedy
Laundry is stained
after washing.
You used liquid detergent or
detergent for colored laundry
which does not contain whitener.
Use the detergent containing
whitener.
White powdery
residues on the
laundry.
It is not the consequence of bad
rinsing, but because of neo-
phosphate detergents containing
non soluble components
(zeolites) for water softening.
Such substances may be
deposited upon the laundry.
Immediately rinse the laundry once
again.
•
Use liquid detergents which do not
contain zeolites.
•
Try removing the residues with the
brush.
Detergent residues in
the dispenser.
Low water  ow pressure.
Some detergents may stick to
the dispenser rather hard if it is
wet.
•
Clean the inlet pipe  lter net.
•
In case of low water pressure
increase water level.
• Wipe the dispenser prior loading
detergent.
Softener is not
completely rinsed,
or water is left in the
dispenser dish.
Sucking cover is not correctly
positioned or is clogged.
Clean the dispenser and  rmly  x the
cover to its place.
Washing time is
longer than usual.
•
The machine switched on
the UKS* system because of
uneven laundry load.
•
Power failure occurred.
•
Washing program time may be
prolonged for 10 minutes and the
machine still functions perfectly.
Time is prolonged for the power
failure period.