SETTING UP YOYO
YoYo Bluetooth Remote Battery
1. Remove the back shell of YoYo
2. Insert the battery into YoYo properly.
Before using YoYo:
1. Check your YoCam and make sure it is charged
before pairing.
2. Read the YoCam quick guide to learn how
to set YoCam in bluetooth mode before pairing.
3. YoYo goes to sleep mode after 1 minute inactivity.
Activate YoYo by pressing any button.
4. It is very important to disconnect YoYo from YoCam
when it is not in use. Continuous connection might
drain the battery quickily.
GETTING STARTED
To Next Page
Loading...