Need help?Do you have a question about the MOGlabs CEL and is the answer not in the manual?
General| Brand | MOGlabs |
|---|---|
| Model | CEL |
| Category | Measuring Instruments |
| Language | English |
Description and location of laser warning and compliance labels.
Shorts laser diode when power is off or laser is off, via a normally-closed relay.
LED illuminates when laser is switched on, with a delay before emission.
Connection for safety interlock on laser head board.
External cavity formed by diode rear facet and cat-eye reflector, using a filter.
Adjusting laser frequency using a piezo electric actuator.
Dependence of laser frequency on temperature and injection current.
Procedure for switching the laser between standby and run modes.
Setting and adjusting the laser diode current.
Optimal temperature settings and equilibrium time.
Adjusting and comparing laser output power.
Adjusting laser wavelength using current, piezo, and filter.
Understanding and identifying mode-hops in laser tuning.
Controlling external cavity length for laser scanning.
Description, mounting, and alignment of Faraday isolators.
Optimizing parameters for wide continuous mode-hop free wavelength scan.
Optimizing feed-forward current bias for synchronizing cavity modes.
Description of filter angle adjustment for wavelength control.
Optimizing the lasing threshold by adjusting focus and current.
Coupling the laser beam into a single-mode optical fibre.
Using a visual fault locator for initial beam alignment to fiber.
Optimizing mirror positions for maximum fiber coupling efficiency.
Specifications for laser wavelength and frequency parameters.
Specifications for laser scan range and mode-hop free range.
Specifications for beam size and polarization.
Details on B1045/B1046 headboards and RF coupling.
Details on B1047/B1240 headboards and SMA input.
Pinout and connection details for headboard to controller cable.
To Next Page
