Need help?Do you have a question about the MOGlabs CEX and is the answer not in the manual?
General| Category | Laser Diode Controller |
|---|---|
| Modulation | Analog |
| Interface | USB |
| Power Supply | 12 V DC |
| Current Noise | < 1.5 nA/√Hz |
Avoid direct exposure, looking into beam, heed labels, understand delay.
Use of STANDBY/RUN keyswitch for safe operation and power control.
Shorted laser diode when power is off or laser is off.
Illuminates when laser is switched on, with a delay before emission.
Provision for connecting a safety interlock if not built-in.
Procedure for setting up and switching the laser between standby and run modes.
Adjusting and comparing laser output power to test report specifications.
Methods for adjusting laser wavelength using current, piezo, and filter screw.
Understanding and managing mode-hops during laser tuning.
Controlling external cavity length with piezo for laser frequency scanning.
To Next Page
