Need help?Do you have a question about the Mohawk MC 300.4DSP and is the answer not in the manual?
General| Channels | 4 |
|---|---|
| RMS Power @ 4 Ohms | 75W x 4 |
| RMS Power @ 2 Ohms | 100W x 4 |
| RMS Power @ 4 Ohms Bridged | 200W x 2 |
| Frequency Response | 20Hz - 20kHz |
| Signal to Noise Ratio | >90dB |
| THD | <0.1% |
| DSP | Yes |
| Input Sensitivity | 0.2V - 6V |
| Crossover | HP/LP/Full |
Covers risks like opening the device, fuse replacement, and environmental exposure.
Focuses on safe installation practices, cable routing, and preventing vehicle damage.
Addresses power supply, capacity, and grounding points to prevent electrical hazards.
Details on connecting the amplifier to the car stereo and power supply via ISO connectors.
Explains amplifier power connection, including separate supply options and auto turn-on features.
Covers fuse replacement, optional AAC signal, and using units without ISO connectors.
Overview of the amplifier's physical controls and the remote for volume and input selection.
Guides on installing, configuring, and using the X-CONTROL software for audio customization.
Demonstrates connecting the amplifier in a stereo system for front and rear speakers.
Provides examples for configuring front/rear channels and optional subwoofer channels.
Guides on adjusting volume, equalizers, and saving/transferring settings within the software.
Details connecting external amplifiers for subwoofers and kickbass speakers.
Explains how to measure and set speaker time delays for optimal sound staging.
Lists detailed technical data for the MC 300.4DSP amplifier.
Lists common issues like no function, no signal, distortions, and their solutions.
Addresses issues like no subwoofer sound, connection errors, and settings recall problems.
Discusses causes of interference, protection circuit, and installation in new vehicles.
To Next Page
