Para español, visite gomohu.com/setup
BOX INCLUDES
SAFETY PROCEDURES
• Make sure there is another person present (on the ground) while
installing the antenna.
• DO NOT attempt to mount the antenna on a windy, rainy or
snowy day.
POWER LINE WARNING
If you intend to mount the antenna on a
rooftop, make sure to mount it at least
20 ft. away from any power lines or
utility poles.
IMPORTANT!
FOLLOW ALL SAFETY PROCEDURES, WARNINGS AND
INSTRUCTIONS WHEN INSTALLING YOUR ANTENNA.
MOUNT THE ANTENNA AT LEAST 20 FT. FROM ALL
POWER LINES OR UTILITY POLES.
20 FT.
MINIMUM
DANGER
Use the included template on the bottom of
this page to mark your mounting surface with
the correct screw placement.
Use the 3/16*32L wood screws for mounting in
the holes you have marked with the template.
You can also insert the included kickstand
in one of the two screw slots to sit the antenna
on a flat surface.
OPTIONAL:
To secure your antenna, install the included
safety bracket above the antenna to block the
antenna from being raised and removed from
the screw slots.
When antenna is sitting on a flat surface, use
the included 90° coax adapter.
1
2
Antenna
OPTIONAL:
OR
8
6
7
Run the free end of the coaxial cable from the mounting location to the
location of the TV. Connect the coaxial cable to the connector on the power
injector. If needed, additional coaxial cable can be added. Excessive cable
may cause reception loss.
Connect the coaxial cable attached to the power injector
to the ANT/IN connector on the back of the TV.
NOTE: If using an RF splitter, turn to the next page
and follow the RF splitter installation instructions.
The power injector must be
powered in order to
function. Plug the
amplifier’s USB cable
into an open USB port
on the back of the TV.
If the TV does not have
a USB port, use the
included power adapter
to power the power injector
via any standard 120V
wall outlet.
Power
Injector
USB Cable (attached)
Coaxial
Cable
(attached)
ANT/IN
Back of TV
a. TV’s USB Port
b. Wall Outlet*
POWER OPTIONS:
3
4
5
*Actual USB power adapter may dier in appearance.
SUPPORT@GOMOHU.COM || 1.855.446.6648 || WWW.GOMOHU.COM
In the TV’s setup menu, set the tuner mode to
“Antenna” or “Air”. Refer to the TV manual for
detailed instructions.
In the TV’s setup menu, set TV to “scan” for
channels. This can sometimes be listed as
auto-program, auto-scan, channel search or
channel scan. Refer to the TV manual for
detailed instructions.
Scanning For Channels
Channel Search
Antenna
Tuner Mode
6
7
beam premium
™
INDOOR / OUTDOOR AMPLIFIED HDTV ANTENNA
*Actual USB power adapter may dier in appearance.
Beam Premium
TM
Antenna
10 ft. Coaxial Cable
6 ft. Coaxial Cable
USB Power Adapter *
Power Injector
Antenna Mounting Hardware
x2 - 16mm Wood Screws
x2 - 3/16*32L Wood Screws
Safety Bracket
Antenna Kickstand
90° Coaxial Adapter
Coaxial Coupler
Attach end of the 10 ft. coaxial cable to the
connector on the antenna.
If you wish to extend the cable, use the
included coupler and 6 ft. coaxial cable.
Coax
Cable
Coax
Cable
Optional
Coax
Coupler
To Next Page
Need help?
General
