What to do if my Mokai ES-KAPE 2.0 engine will not start?
If your Mokai Boat engine won't start, there are several potential causes: * The choke may be off and the safety lanyard not attached. Put the choke to the 'on' position. * You might be out of fuel. Refuel your boat. * The engine key could be in the 'off' position. Turn it on. * The battery might be dead. In this case, pull the cord located on the engine.
What to do if my Mokai ES-KAPE 2.0 Boat has abnormal pump performance?
If your Mokai Boat exhibits abnormal pump performance, consider these possibilities: * The intake grate might be clogged with weeds or debris. Turn off the engine, remove the debris, and then restart the engine. * Weeds could be tangled around the driveshaft. Remove the jet drive (on land), remove the tangled debris, reinstall the pump, and restart the engine. Inspect for any damage. * There might be damage to the driveshaft or coupler. Inspect these components. * Pump inefficiency can also cause this problem. Call MOKAI Manufacturing to inspect the (green) wear ring located at the stern where the jet drive attaches, and replace if needed.
How to fix no fuel to engine in Mokai ES-KAPE 2.0 Boat?
If there's no fuel reaching the engine of your Mokai Boat, check the following: * Ensure the fuel lines are properly connected. If not, connect them. * Verify that the fuel shut-off valve is open. If it's closed, open the valve. * Inspect the vent line for clogs. If clogged, blow the line clear.
To Next Page
General