Need help?Do you have a question about the molex TCDEC-8B4B-DYU-GW and is the answer not in the manual?
Modules are engineered for proper use as described in this documentation.
No changes or modifications should be made to the product not approved by manufacturer.
User must work safely and adhere to regulations.
Warning about risk of injury from insufficient qualification.
Wearing of PPE is needed to minimize health hazards during work.
Identifies residual risks from hazard analysis and safety warnings.
Details technical specifications of the HarshIO safety module.
Details EtherNet/IP, IP setting, protocol, data access, connections, CIP objects.
Provides dimensions, housing material, operating temp, etc.
Explains LED positions, status, and states for diagnostics.
Module powered by 2 separate 24 VDC supplies.
Module embeds a dual-port Ethernet switch identified by ETH1 and ETH2.
Shows safety input wiring with corresponding safety categories.
Shows safety output wiring for single and dual channel configurations.
Guidance for commissioning HarshIO modules with SNCT and RSLogix.
Steps to configure module in RSLogix 5000 project.
Using Molex Safety Network Configuration Tool (SNCT) for module configuration.
Connecting and testing module signature in RSLogix 5000.
Explains how to replace a defective product using the memory key.
Step-by-step guide to successfully replace a module.
Checks for common situations after new module installation.
Molex Safety Network Configuration Tool (SNCT) for HarshIO configuration.
Resets ownership between scanner and module, or factory settings.
Protects module configuration from modification after commissioning.
Allows setting or resetting a password for SNCT features.
Allows updating the HarshIO module firmware.
Describes M8 and Window memory keys for storing configuration.
General| Brand | molex |
|---|---|
| Model | TCDEC-8B4B-DYU-GW |
| Category | I/O Systems |
| Language | English |
To Next Page
