Need help?Do you have a question about the Molteni&C 505 and is the answer not in the manual?
Start assembly by inserting wooden pegs into the base and placing it against the side partition.
Screw shelf pivots into the desired position and insert the shelf by sliding the pivots into the side grooves.
Mount the compartments from bottom to top following the diagram shown.
Diagrams indicating correct shelf assembly for double face units.
Screw pivots into shelves and insert partitions by sliding pivots into grooves.
Instructions for attaching a glass door hinge to the cabinet frame.
Attaching the flap door to the structure using the clasp and inserting the winch cable.
Assemble the arm and adjust the door's opening force using a hex key.
Assemble the brace and regulate the intensity of the opening force.
Instructions for attaching the fixing bracket A and ensuring the bar B fits in the compartment.
Check spacers, insert and fasten bar B by screwing plates C and bearings 2.
Insert door from top to bottom, support it, and insert trolley sliders into runners.
Align threaded bearing with flared hole, tighten screws, lower door, and attach bracket A.
Adjust parallelism, overlap, and balancing force for the sliding door.
Assembly of the TV compartment, including upper surface, reinforcement beam, and back panel.
Insert partitions, screw them to sides, pull out guides, place drawer, and hook inserts.
Fix drawer guides, pull out guides, place drawer, and hook inserts.
Adjust drawer front position in height and depth using cursors and regulators.
Trace attachment points, insert bolts, and screw plates to the wall.
Trace attachment points, insert chemical bolts according to wall material.
Hook panels, attach base, insert back/cover, attach right panel, adjust regulators for height and level.
Attach panels, base, backs, and right panel, then adjust regulators.
Insert spacers in tray, screw under base, insert power boxes, or insert boxes in hanging base tray.
System functions only if compartment is closed. Position devices under transmitter.
Place lower plinth with tracks, screw into inserts, place door, fix to lower tracks.
Screw upper runner pivots into side shoulders, then insert sliding brackets into upper runner.
Fit sliding upper runner to the structure and fix with screws.
Screw upper runner bars to door, reposition bars if rubbing, check overlap, adjust screws.
Insert springs in collar, position, and clip to runner.
Place lower plinth with tracks, screw into inserts, place door, fix to lower tracks.
Screw upper runner bars to door, reposition bars if rubbing, check overlap, adjust screws.
Insert springs in collar, position, and clip to runner, adjust door using tensors.
Make holes, insert support, pull out shelf if tilted, screw dowel to return to horizontal.
General| Category | Indoor Furnishing |
|---|---|
| Brand | Molteni&C |
| Model | 505 |
| Designer | Rodolfo Dordoni |
| Upholstery | Fabric or Leather |
| Type | Sofa |
| Padding | Polyurethane foam |
To Next Page