MoMi LUIS - Product Assembly

EN8
COMPONENTS:
1. Upper Rails (2pcs)
2. Lower Rails (2pcs)
3. Kickstand
4. Cross Brace
5. Music box tube
6. Seat back tube
7. Toy bar
8. Music box
9. Pad
10. Screw bag
PRODUCT ASSEMBLY:
Take out all the parts from the package, carefully check all the parts with the parts list.
1.Side Rail Assembly
1.1 Connect the top rail and the bottom rail „L”. Insert the foot into the hole in the plastic part of
the top rail. Insert a M5*44mm screw into the hole in each side rail and tighten. Repeat the assembly of
the right side using part „R”, Fig. 1.
1.2 Mount the cross rail between the side rails by inserting the ends into the holes in the plastic
parts of the side rails (g. 2) Insert a M5*30mm screw into the hole in each side rail and tighten.
2. Music Box Tube Assembly
2.1 Insert each side of the music module tube into the plastic holes in the side rails, press until
the hole clicks, insert the M3*15mm screw into the holes in each side rail and tighten, see g.3.
3. Seat Tube Assembly
3.1 Insert both ends of the seat backrest tube into the holes in the plastic part of the upper side
rails, press it as far as possible until you hear a click - it means that the part has been properly installed.
Insert the screws into the holes in both side rails and tighten (g. 4).
4. Pad Assembly
4.1 Put on the textile pad by hooking the upper part of the pad to the seat tube. Then put the
lower part of the pad on the music box module tube. Fasten the buckles on both sides of the pad around
each side rail. A click sound means that the buckles have been properly closed.
5. Music And Vibration Box Assembly
5.1 Remove the screw on the bottom of the music and vibration module. Remove the cover
and insert two AA alkaline batteries into the module according to polarity. Close the box and tighten the
screw.
ATTENTION! Batteries are not included.
5.2 Insert the music and vibration module into the tube of the music module, Fig. 6.
6.Toy Bar Assembly
6.1Install the toybar by inserting its ends into the buckles on the sides, Fig. 7.