To Next PageTo Next Page
Need help?Do you have a question about the Monacor HPB-240/SW and is the answer not in the manual?
Adjusts bass and treble frequencies for audio output.
Selects crossover frequency for subwoofer operation (80/120 Hz).
Adjusts the input signal level for optimal matching.
Connects the booster to audio sources via line-level signals.
Details fuse ratings for HPB-240 (20A) and HPB-260 (25A).
Connection point for the unit's ground wire.
Input terminal for the main power supply connection.
Input for +12V signal to switch the booster on/off.
Displays unit status (green for operation, red for protection).
Terminals for connecting speakers to the amplifier.
Important safety advice for handling, mounting, and operation.
Warnings regarding potential hearing damage from high volumes.
Guidelines for selecting a suitable and secure mounting location.
Details on connecting the +12V and GND terminals and fuse sizing.
How to connect audio sources to the booster's line inputs.
Methods for connecting speakers, including two-speaker and bridged modes.
Procedure for matching booster input levels with the car radio.
Steps to diagnose issues when the unit's LED does not light up.
Troubleshooting steps when the LED is green but no audio output.
Explanation of the red LED and causes like short-circuits or overload.
Specifies the audio frequency response of the booster.
Details maximum and RMS output power for HPB models.
Defines the speaker impedance compatibility.
Information on line input types and sensitivity range.
Measure of audio signal isolation between channels.
Indicates the level of unwanted noise in the audio signal.
Measures the distortion level in the audio output.
Specifies voltage range and current draw for operation.
Provides unit dimensions (WxHxD) and weight for each model.
Adjusts bass and treble frequencies for audio output.
Selects crossover frequency for subwoofer operation (80/120 Hz).
Adjusts the input signal level for optimal matching.
Connects the booster to audio sources via line-level signals.
Details fuse ratings for HPB-240 (20A) and HPB-260 (25A).
Connection point for the unit's ground wire.
Input terminal for the main power supply connection.
Input for +12V signal to switch the booster on/off.
Displays unit status (green for operation, red for protection).
Terminals for connecting speakers to the amplifier.
Important safety advice for handling, mounting, and operation.
Warnings regarding potential hearing damage from high volumes.
Guidelines for selecting a suitable and secure mounting location.
Details on connecting the +12V and GND terminals and fuse sizing.
How to connect audio sources to the booster's line inputs.
Methods for connecting speakers, including two-speaker and bridged modes.
Procedure for matching booster input levels with the car radio.
Steps to diagnose issues when the unit's LED does not light up.
Troubleshooting steps when the LED is green but no audio output.
Explanation of the red LED and causes like short-circuits or overload.
Specifies the audio frequency response of the booster.
Details maximum and RMS output power for HPB models.
Defines the speaker impedance compatibility.
Information on line input types and sensitivity range.
Measure of audio signal isolation between channels.
Indicates the level of unwanted noise in the audio signal.
Measures the distortion level in the audio output.
Specifies voltage range and current draw for operation.
Provides unit dimensions (WxHxD) and weight for each model.
General
