Monarch PLT200 - PREPARATION FOR MEASUREMENT; Non-Contact Preparation Steps; Direct Contact Preparation Steps

E-10
7.0 TAKING MEASUREMENTS
7.1 Non-Contact Measurements
7.2 Direct Contact Measurements
Hand-held
Laser
External Sensor (ROS shown)OR
Light
WARNING: Making measurements in direct contact with rotating
equipment can be dangerous. Keep all loose clothing and hair
away from exposed moving machinery. Keep the hand holding
the instrument well behind the back end of the Remote Contact
Assembly. Properly replace all machinery guards after completing
measurement. Do not use for rotation greater than 20,000 RPM.
to RCA
from PLT200 from PLT200
Rotational Linear
(Use concave
tip for small
shafts)
ONLY USE MODERATE PRESSURE
S-13
1. Encender
la unidad
EXTRN, luego mensaje
avanza, luego últimas
unidades seleccionadas
9.0 Modo VELOCIDAD (RATE Mode)
NOTESE: Dispositivo externo de contacto remoto (RCA) debe de ser
introducido al enchufle de entrada.
9.1 Arreglo Para Modo Velocidad
Medir
Llamar valor
Máximo
guardado
Llamar valor
Mínimo
guardado
Si la unidad esta
fijada en modo
continuo:
Apagar
Velocidad
Mínima
Velocidad
Máximo
Se apaga automáticamente después
de 90 segundos si la unidad no esta
fijada en modo continuo
O
Mantenga presionado
Fijar (Lock-on)
Reinicia Max/Min
O
8.2 Operación de Modo TACHómetro
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com