18
• Always provide enough, but safe, distance between the child and the
tray.
• Be careful when adjusting the position of the tray, the footrest and
when unfolding or folding the chair, as there is a risk of pinching your
fingers.
• Use the tray always in combination with safety belts! The tray is not
intended to protect the child from falling.
• Never lift, move, fold, adjust or repair the seat when there is a child in
it. This can injure the child.
• Always before use, check the functioning of the locking mechanisms.
• Before placing the child in the seat, make sure that it is fully unfolded
and locked in the open position and that all locking mechanisms are
tightly closed! This will prevent the child from being injured by sudden
folding of the chair.
IMPORTANT! The diagrams and figures in this instruction are illustrative and
indicative only. Follow exactly the instructions and sequence for assembling
and operating with the product.
Check the securing of the fixation after each operation. Fixing a certain position
in most cases is accompanied by a clicking sound.
COMPONENTS – FIGURE PD: 1. Seat compartment; 2. Double tray; 3. Front
support and rear support tube (legs) – 2 pieces; 4. Rear support tube (leg);
5.Castors.
PRODUCT ASSEMBLY – FIGURE A: WARNING! Make sure that the base is
assembled correctly and is stable, this ensures the safety of your child!
Strictly follow the instructions and sequence for assembling the product as
shown in the diagrams.
1. Assemble the seat by inserting the upper support frames, left and right, into
the seat coupling holes in the direction of the arrows (see Figure A.1). You have
to hear a clicking sound. Attention! When installing the upper support frames,
pay attention to their clear distinction, which is left and right.
2.Install the front and rear support tubes to the assembled seat frames as
shown in Figure A.2. Push until you hear a clicking sound and the spring-loaded
tabs tighten and pop out of their holes (Figure A.2).
To Next Page
Loading...