19
3.Place the castors at the bottom of the legs as shown in Figure A.3. To lock
the castors, use the locking mechanism placed on the castors themselves.
INSERTING, ADJUSTING AND REMOVING THE FEEDING TRAY:
Place the feeding tray as you put it over the armrest and press the sideway
buttons to the needed position (Figure A.4). You have to hear a clicking sound.
The tray can be adjusted in 4 positions. Press the side button to adjust the tray
position and slide it together with the slot to the desired position. For taking
down the tray, press the sideway buttons of the tray and remove it. Top stand
can be removed as: 1. By holding and pulling from the holes, and lifting the
other protrusions and removing. To reinstall, place the top tray over the
bottom tray and press it.
SEAT HEIGHT AND BACKREST INCLINATION:
- Seat height adjustment – 5 levels: By pressing the side button of the frame
you can move the seat down or up. The seat has 5 levels of height adjustment.
- Backrest inclination adjustment – 3 levels: Hold the button on the back of
the chair and pull the seat back to the desired position.
Attention! Do not change the height and inclination of the seat when a child is
seated in the high chair.
INCLINATION OF THE FOOTREST: To adjust the angle of the footrest, press the
two side buttons at the same time, there are 3 options.
FOLDING THE HIGH CHAIR: Put the seat in the lowest position. Press the
buttons on bothe sides of the high chair and slide the rear legs forward, fold
the high chair.
USING THE 5-POINT SEAT BELT:
The five-point seat belt is designed to ensure the safety of your child and must
be used at all times. Unbutton the mechanism before placing the baby. To
unfasten the belt, press the buckle button and pull the fastener. To fasten the
belt, insert the belt buckles at the waist into the holes in the buckle and press
until they lock. Place the baby and fasten the belts (you will hear a "click" sound
when properly fixed in the buckle). Sliding controls are mounted on the straps
and waist belt. The straps should be carefully adjusted to the child's comfort.
Check the restraint system by pulling it slightly away from your child. The
restraint system must remain attached.
Clean only with a soft, dry cloth.
To Next Page
Loading...