REMOTE CONTROL USE
ONLY AN ADULT CAN USE THE REMOTE CONTROL!
The use of the remote control is always with priority over the manual and pedal operation with the SUV.
(If you use the remote control, the pedal will not work.)
I. PLACING OF THE BATTERIES:
WARNING! The placement of batteries should be performed in the absence of children!
1.The batteries are not included in the set.
2.Remove the screw of the lid of the battery compartment with a screwdriver and set it aside.
3.After that place 2 pcs AAA (LR03) batteries in the compartment, make sure that you observe the respective polarity (+/-)
when you place them, it is indicated on the bottom of the compartment.
4.Replace the cover of the battery compartment and secure it with the screw.
5.The batteries must be handled by an adult. Do not allow the children to play with the batteries.
6.Warning! The placing of the further change of the batteries must be done by an adult.
II. Buttons of the remote control – See Figure RC:
- F – Forward – press in order to move the SUV forward;
- B – Backward – press in order to move the SUV backward;
- L – Turn on the left– press in order the SUV to turn on the left;
- R – Turn on the right – press in order the SUV to turn on the right;
- SS – Speed select – press in order to move the SUV with low, normal and high speed;
- SPL – LED indicating light for the different speeds;
- S – Brake – press in order to stop the SUV from moving;
- SI – status indicator;
- C – connection button.
III. Connecting the remote control device to the SUV: Press C button for 2 seconds until the situation indicator flashes.
Then turn on the SUV Power. If the situation indicator turns off for 2 seconds and then turns into long light, then you have
connected successfully the remote control to the SUV. If the status indicator makes no response, then the connection was
not successful. Take out and replace the batteries. Repeat the actions above to try to connect the RC to the SUV.
NOTE:
1. If you do not use the RC for 10 seconds, it will turn off automatically.
2. When you change the old batteries with new ones, you have to re-connect the RC to the SUV.
Moni Trade Ltd., hereby, declares that this type of radio equipment model XMX603 complies with Directive
2014/53/EC. The complete text of EC declaration for compliance can be found at the following Internet address:
www.moni.bg.
IV. IMPORTANT INFORMATION ABOUT THE BATTERIES:
1. Always remove the discharged batteries and do not throw them away with the household waste, use the places
designated for that purpose. They are recyclable.
2. Use only batteries with the size and voltage, marked on the bottom of the battery compartment.
3. Alkaline batteries are recommended.
4. Always remove the batteries, if you will not use the product for a long period of time.
5. When you replace the batteries always replace them with new ones, always replace all batteries. Children should not be
present while you are replacing the batteries.
6. Do not mix old batteries with new ones.
7. Do not mix alkaline, standard (Carbon - Zinc), or rechargeable (Nickel – Cadmium) batteries.
8. Do not throw the batteries in fire, because they may blow up or leak.
17
CHARGING THE BATTERY – FIGURE CH
ONLY AN ADULT CAN CHARGE AND RECHARGE THE BATTERY!
WARNING
•IN ORDER TO AVOID FIRE AND ELECTRIC SHOCK:
-NEVER USE battery or charger of other brand or another product. Always use only the rechargeable battery and adapter
provided with the bought product.
-Do not place the battery or adapter for another product. This may result in overheating, fire or explosion.
-NEVER change the electric current. Making any changes to it may lead to short circuit, fire or explosion or the system may
permanently get damaged.
-Do not allow Your child to charge the battery.
-DO NOT ALLOW DIRECT CONTACT BETWEEN THE TERMINALS OF THE BATTERY. THIS MAY LEAD TO FIRE OR
EXPLOSION.
•During the charging of the battery explosive gases, heat or flammable substances accumulate. Charge the battery in well
ventilated places ONLY.
To Next Page
Loading...
