Need help?Do you have a question about the Monico CDL Gateway and is the answer not in the manual?
Power| power voltage | 24 VDC ± 10% |
|---|---|
| current without expansion card | 200 mA min. |
| current with expansion card | 1 Amp maximum |
Communications| USB/PG port specification | USB 1.1 |
|---|---|
| serial port baud rate | up to 115, 200 baud |
| Ethernet port type | 10 BASE-T / 100 BASE-TX |
Memory| on-board user memory | 4 Mbytes |
|---|---|
| on-board SDRAM (DSPSX) | 2 Mbytes |
| on-board SDRAM (DSPGT) | 8 Mbytes |
Operating Environment| operating temperature range | 0 to 50°C |
|---|---|
| storage temperature range | -30 to +70°C |
| operating and storage humidity | 80% max relative humidity, non-condensing |
Guide to installing necessary USB drivers for the MonicoView software.
Configure ports, parameters, TCP/IP, and view live data in MonicoView.
Details on Modbus RTU/TCP/IP slave modes and master options.
Pre-assigned address system for Modbus function codes 3 and 4.
Explains conversion of raw Modbus values to actual engine data.
Address system for simulating Monico CCM Translator Modbus addresses.
Details on converting Modbus register values to actual engine data.
Use of Analog Input Registers (AI1001) for GE Fanuc PLC integration.
Viewing installation-specific parameters in registers AI2001-AI2xxx.
Using ControlLogix/CompactLogix with controller tags and CSV export.
Native Data Tag system (INT, DINT, REAL) for Allen Bradley PLCs.
To Next Page