In
troduction
Monit
or
Audio is a wholly British owned and managed loudspeaker designer and manufacturer.
Since 1972, it has been at the leading edge
of
loudspeaker design and technology, perfecting the
implementation
of
metal drivers. It is renowned for exemplary speaker cabinet construction and finish.
In 2017, Monitor Audio purchased Roksan, a brand that has created award-winning audio products in
the UK for over thirty years. Extreme attention
to
detail and an uncompromising approach
to
quality has
inspired a range of turntables, CD players, amplifiers and streaming systems that are enjoyed throughout
the world.
Guarantee
Both the craftsmanship and the performance of this product is guaranteed against manufacturing
defects for the period
of
five years from the date
of
purchase (see conditions
in
the Important Safety
Instructions booklet), provided that the product was supplied by an authorised Monitor Audio retailer
under the consumer sale agreement.
To help us find your warranty details within our customer database, should the need arise, please take a
few minutes
to
register your product(s) online at: monitoraudio.com.
Subwoo
f
er
Position
ng
and
Set
Up
Initia
l
Set
Up
~
Leave the subwoofer unplugged from the mains until all signal cables are connected
~
and
feet
attached.
Fix
the feet
to
the bottom
of
the subwoofer using either the screws supplied into the pilot holes
or
by
screwing the foot directly in
to
the inserts on the bottom
of
the cabinet depending on the model.
The subwoofer should
now
be sited in the most suitable position, preferably not directly in the corner
of
a room as this may cause excessive bass boom. Once a desirable position is achieved it is important
to
check if the cables are long enough
to
reach comfortably without being under tension. Cables should
be
less than 1 O metres
to
avoid interference.
~
WARNING: Never connect
or
disconnect the RCA input/ output leads with
the
~
subwoofer switched on.
For initial setting up, put the Power Mode
Sw
itch in the 'On' position and leave the 12v trigger cable
(if
being used) disconnected.
Once the input cables are
co
nnected and the power mode switch is in the On position, the subwoofer
can be connected
to
the mains power supply and switched on at the mains power switch.
Connecting
to
an
AV
Recever
The majority
of
AV
amplifiers have automatic setup systems. If your amp has an auto set up procedure,
run this now with the volume set
to
around 1 O - 12 o'clock, and the power mode switch
in
the On
position.
When the auto set up is complete check the settings on the
AV
amp
for
the sub woofer
to
ensure they
are correct. If not
we
would suggest adjusting accordingly.
Now
play a variety
of
music/ film excerpts that you are familiar with gradually
in
creasing the volume
to
an
average listening level once you are sure everything is working correctly
monitoraudio.com
To Next Page
Loading...
Need help?
General
