Need help?Do you have a question about the Monitor Audio IWA-250 and is the answer not in the manual?
General| Type | Class D |
|---|---|
| Frequency Response | 20 Hz - 20 kHz |
| Signal-to-Noise Ratio | >100 dB (A-weighted) |
| Input Impedance | 10 kΩ |
| Damping Factor | > 200 |
| Channels | 1 |
| Power Output | 250W RMS @ 4 Ohms |
| Total Harmonic Distortion | <0.1% (20Hz - 20kHz at full power) |
Guide on attaching self-adhesive rubber feet for shelf/cabinet mounting.
Instructions for fitting mounting brackets for rack installation.
Describes the 12V trigger input for external control via AV receiver or amplifier.
Explains RCA stereo input connection for stereo amplifier systems and crossover frequency setting.
Details the LFE input for AV receiver/processor connection where crossover is controlled externally.
Explains the function and proper use of the main power switch for standby and operation.
Troubleshooting steps for issues preventing the amplifier from turning on or receiving power.
Troubleshooting steps for diagnosing and resolving problems where no audio output is detected.
To Next Page