Mono MM

SECTION 1 INSTALLATION
START-UP PROCEDURE
ASSEMBLY AND DISMANTLING ADVICE
SECTION 2 FAULT FINDING
SECTION 3 DRAWING REFERENCE NUMBERS
PUMP CODING SHEET
SECTION 4 DISMANTLING AND ASSEMBLY DIAGRAMS
EXPLODED VIEWS
SECTION 5 TORQUE TIGHTENING FIGURES
Index
EC Declaration of Incorporation
This declaration is only valid when partly completed
machinery has been supplied.
In this case, the machinery meets the requirements of the
said directive and is intended for incorporation into other
machinery or for assembly with other machinery in order
to constitute relevant machinery as defined by the said
directive including any amendments, which are valid at the
time of supply.
IMPORTANT
This machinery must not be put into service until the
relevant machinery into which it is to be incorporated has
been declared in conformity to the said directive.
This declaration is only valid when the machinery has
been installed, operated and maintained in accordance
with these instructions and safety guidelines contained
within as well as instructions supplied for equipment
assembled with or intended for use with this equipment.
The following harmonised standards are applicable: BS EN 809,
BS EN ISO 12100 Parts 1 & 2
EC Declaration of Conformity
This declaration is not valid for partly completed machinery
has been
supplied.
In this case the machinery meets the requirements of the
said directive including any amendments which are valid at
the time of supply.
We further declare that, where applicable, said machinery also
meets the requirements of:
The EMC Directive 2004/108/EC
The Low Voltage Directive 2006 /95/E
The Pressure Equipment Directive 97/23/EC
The Outdoor Noise Directive 2005/88/EC
The Drinking Water Directive 99/83/EC
IMPORTANT
This declaration is only valid when the machinery has been
installed, operated and maintained in accordance with these
instructions and safety guidelines contained within as well
as instructions supplied for equipment assembled with or
intended for use with this equipment.
Mr C. Q. Griffiths - Engineering Services Manager.
for Mono Pumps Limited, Martin Street, Audenshaw,
Manchester England, M34 5JA
Index
Issued – December 2009
EC Declaration
as defined by Machinery Directive 2006/42/EC.