Monogram Systems
COMPONENT MAINTENANCE MANUAL
BASIC PN 15900
38-31-09
Page 710
May 17/02
D. Timer Assembly, PN 11059-79 (refer to IPL Figure 4)
(1) Procedures
(a) If removed during disassembly, install identification decal (75).
(b) Install grommet (70), sockets (90), plug (85), pins (65), plug (60), clamp
(55), connector (50) and disconnect (45).
(c) Install PC Board assembly (15), using screws (40), terminal lug (35), lock
washer (30), washers (25) and nuts (20).
(d) Install timer plate (5) in timer enclosure (80) using screws (10).
(2) Storage Instructions
(a) List of Materials
NOTE: Equivalent substitutes may be used for listed items
ITEM IDENTIFICATION SOURCE
Bag Plastic Commercially
available
Barrier Material MIL-B-121 Any Source
(b) Instructions
If the timer is to be stored after overhaul, seal in a plastic bag, wrap with
barrier material and place in a cardboard carton. Mark part number and
date of overhaul on outside of carton.
To Next Page
Loading...