Monosem NG Plus - Changing the Drive Range (12;25 Sprocket)

3 7
The dosehectare is adjusted using the variator selector A. This adjustment depends on the inter-row spacing and the product used.
The table opposite provides indicative adjustments source AGPM that must be checked in practice. To perform the adjustment
For an accurate adjustment, perform a calibration
1 - Put the product in the righthand Microsem hopper.
2 - Move the variator selector to mark 10 loosen thumbwheel C, turn thumbwheel C and retighten thumbwheel C.
 - Use a tray to collect the product from the 2 outlets.
4 - Perform 50 wheel revolutions.
5 - eigh the product collected from the 2 outlets.
 - Determine the adjustment mark by applying the following euation
MARK = uantity reuired kgha   interro sacings cm
uantity eighed in gr
If the value calculated is less than 1 or greater than 10, change the drive range and calibrate again from point 2.
7 - Move the variator selector to the mark calculated loosen thumbwheel C, turn thumbwheel C and retighten thumbwheel C
A   A  
The Microsem drive systems engine sprocket is a 2 tooth cluster sprocket 12 and 25 teeth, providing the option of two ranges.
To change the range
1 - Remove the drive casings.
2 - Change the position of the chain.
 - Alter the position 12 tooth sprocket or 25 tooth sprocket.
4 - Ret the casings.
eeral arameters may cause the o rates to ary article size, hygrometry, etc.. hey must therefore be
checked in ractice, through a rior test, so that the adjustment may be corrected, if necessary, to actually obtain the
dosehectare reuired.
A  aies any liability for the adjusting of the o rate, hich is u to the users discretion.
sigairtó granulátum  ранулированное средство для борьбы с улитками  elicide granules
Allowin
5 kgha
agisem
5 kgha
esurol ro
2 kgha
étare 
5 kgha
tralugec 
7 kgha
luaol
2,5 kgha
ogaskerékmotor
Ведущая
шестерня
otor srocket
1 2 2 5 1 2 2 5 1 2 2 5 1 2 2 5 1 2 2 5 1 2 2 5
cm
Kukorica
. . . . .  .  . . . .
cm
Kukorica
. . . . . . .  . . . .
cm
Napraforgó
. . . . . . .  . . . 1
cm
Napraforgó
C ékl a„
. . . . . . 1  . . . 
őtengelyjelzés  fog  Контрольное положение переключателя  или  зубьев  ariator mark  teeth
12D / 25D
Changement de gamme
Axe moteur / Roue
Châssis EXTEND
Axe moteur / Roue
12D / 25D
Changement de gamme
12D / 25D
Changement de gamme
Axe moteur / Roue
Châssis MONOBLOC 2 Châssis trainé 8 rangs WingFold
A fenti beálltások csak tájékoztató jellegűek. Az indtáskor történő ellenőrzés továbbra is kötelező.
Нижеуказанные регулировки являтся лишь рекомендуемыми. вод оборудования в эксплуатаци необходимо осуествлять под контролем.
The above settings are only indicative. A start-up check remains compulsory.