Need help?Do you have a question about the Monport 40W and is the answer not in the manual?
Provides visual representations of the Monport 40W laser engraver controller, showcasing its design and ports.
Illustrates the physical layout of the controller board, identifying key components and connection points.
General| Laser Power | 40W |
|---|---|
| Control Board | M2 Nano |
| Laser Type | CO2 |
| Cooling Method | Water Cooling |
| Power Supply | AC 110V±10% 60Hz |
| Control System | M2 Nano |
| Software | LaserDRW |
| Positioning Accuracy | 0.01mm |
| Repeat Positioning Accuracy | 0.01mm |
To Next Page