(J) TROUBLESHOOTING GUIDE
Problem
The vehicle does not move
The vehicle begins to run slow
The vehicle runs erratically
The charger feels warm when in
use
The gears sound very loud and/or
are making a grinding noise.
Possible Solutions
· Charge the battery. (Charge battery after each use.)
NOTE: vehicle will be cut off from electricity when charging.
· Check all electrical connections.
· Check if all switches are in the "on" position.
· Check if foot pedal or manual button is stuck down so
that it cannot be pressed.
· The fuse may have been activated due to excessive
weight or rough driving conditions. Wait approximately
10~20 seconds, and the vehicle will reset itself.
· Check if there is debris blocking the wheels.
· Charge the battery. (Charge battery after each use.)
· Only allow one rider at a time.
DO NOT exceed child weight limit: 40kg total
· Drive on level ground.
· Battery may be old or not accepting a full charge. The
battery will last from 1 to 3 years depending on care,
use and environment.
Replace with 12 Volt 7Ah battery only.
· Check if there is debris blocking the wheels.
· There may be a problem with the fuse, or you may
have a damaged battery.
· This is normal.
· The gears may be broken.
9
Audits should check all screws, cap nuts and their protective coverings regularly
and tighten as required. Check plastic parts on a regular basis for cracks or
broken pieces.
When vehicle is not used on a regular basis, the vehicle should be stored inside
or under a protective cover. With the switch in the "off" position, pull out the battery
to ensure circuit safety. Remember to charge the battery at least once per month
while your vehicle is not in regular use.
Avoid operating the vehicle in wet, rainy or snowy conditions.
Avoid operating the vehicle on sand, loose dirt or gravel. Sand, loose dirt or
gravel in the motors or electrical switches can cause them to jam, and could
cause switch or motor failure.
The vehicle can be wiped down with a soft, dry cloth.
DO NOT wipe vehicle with wax.
DO NOT wash the vehicle with soap and water or spray the vehicle with a hose.
Water or moisture in the motors or electrical switches can cause them to
corrode, and could cause switch or motor failure.
DO NOT make modifications to this vehicle. When conducting maintenance, do
not revise the vehicle's circuit and structure.
ONLY use the battery and charger specified by the manufacturer.
In the unstable supply voltage region, it is recommended to install a voltage stabilizer
to protect the battery.
(I) CARE AND MAINTENANCE
To Next Page
Loading...
