Basic operation
Charge the Battery
Your iSport® Wireless initially has enough power to
complete the pairing and a few calls. When battery
is low, you will hear “Battery low” around every 5
minutes and “Recharge” when the battery needs
to be recharged and the indicator light changes
to red. The headphone includes a Micro USB cable
that can be connected to your computer or other
device made for USB charging. Plug the Micro USB
end of the included USB cable into the USB micro
port charger connector on the right channel side
of the headphone. Plug the other end into a USB
port on your computer or other devices made for
USB charging. The indicator light will be red while
charging. Once fully charged, the indicator light
will be blue. Charge time is approximately 1.5 hours
on an empty battery.
Note: The lifetime of the battery will be signicantly
reduced if your headphone is left uncharged for a
long period. We recommend that you recharge your
headphone at least once a month.
Power On/ Power O
Press the Multifunction button for about 1-2
seconds to power on the headphone. To power o
the headphone, press the Multifunction button for
about 3-5 seconds.
Volume Control
Press the Volume “+” or “-” to turn volume up
or down, you hear beep once you reach the
maximum volume.
Pairing
Pair One Phone
1. Press and hold the Multifunction button for
about 5 seconds until indicator light ashes
blue and red alternately, you hear “Power
on” then “Pairing”. Now
headphone
is in
pairing mode.
2. Activate Bluetooth® on your phone and set it
to search for new devices.
3. Select “iSport Wireless”. If your phone asks,
enter 0000 (four zeros) for the passcode or
accept the connection. The indicator light
stops ashing red and blue once successfully
paired, you hear “Connection successful”.
Some phone list an option to “Play through
earphone”, select to use the
headphone
.
To Next Page
Loading...
