Need help?Do you have a question about the Montanari M50P and is the answer not in the manual?
Procedures for unloading the lift gear from the carrier.
Safe methods for lifting and moving the lift gear.
Instructions for mounting the lift gear onto its base.
Guidelines for oil filling and level check for the lift gear.
Specific lubrication instructions for Penta and Penta 830 models.
Wiring schemes and instructions for the electrical motor.
Procedures for initial startup and testing of the lift gear.
Fine-tuning procedures for brake shoe settings.
Procedure to check axial clearance of the thrust bearing.
Procedure to check gear clearance and admissible values.
Procedure to check and replace brake shoes.
Guidelines for oil changes and topping up.
Procedure to check for oil leaks from seals.
Procedure to check traction pulley groove wear.
Instructions for replacing components.
Specifies torque values for screws.
General| Type | Pressure Transmitter |
|---|---|
| Application | Industrial pressure measurement |
| Pressure Range | 0...100 mbar to 0...600 bar |
| Output Signal | 4...20 mA |
| Electrical Connection | DIN 43650, M12 connector, or cable gland |
| Operating Temperature | +85°C |
| Protection Rating | IP65 |
To Next Page