CK-300-ENG
1. Model CD-52, manufactured by Ja Yang (E106510)
CK-300
Top view of switch housing plate.
2
Disconnect Molex Connectors in switch housing
plate by pushing down on tab and pulling the
two (molex connectors) apart.
3
CAUTION: To reduce the risk of electric shock,
install only in Fan
CAUTION : FOR CONTROL OF SHADE POLE, PERMANENT SPLIT
CAPACITOR, OR UNIVERSAL MOTORS ONLY.
Connect the molex from the receiver to the
molex in the switch housing plate b
y aligning
and sliding together. Note: For longer distance
operation, coil receiver antenna around the
natural wire (white wire).
4
Align gap in receiv
er with the screw between
speed switch and reverse switch and slide
receiver (Dip switch facing housing plate) into
switch housing plate. R
eceiv
er should fit direct
-
ly into area in the switch housing plate. Note:
If installing light kit, use the blue and white
wire from the receiver.
6
Set dip switches on the R
emote T
r
ansmitter and
Remote Receiver to the same settings. This
must be done so the units will communcate
properly. If you have other fans you can set to
control from one tr
ansmitter b
y setting both
receivers the same as the transmitter. If you
ha
v
e more than one fan with remote. You can
set the dip switches to different positiosns to
have seperate control.
Remote Transmitter Dip swtiches
Remote Receiver Dip switches
5
2. Model 9701, manufactured by Furn Fan (E141261)
3. Model AC-552, manufactured by Air Cool (E75795)
For Monte Carlo Remote
Caution: T
urn off power at fuse box to avoid
possible electrical shock.
1
To Next Page
Need help?
General
