EasyManuals Logo

Monzana DBKA002 User Manual

Monzana DBKA002
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
www.Deuba24online.de www.Deuba24online.de
INSTRUCTIONS FOR USE
1. When using the appliance, make sure that it is on a at and stable surface. Damage may occur if it is
placed on an incline or decline and put the ice box into water tank:
2. Insert the plug directly into a standard AC
socket-outlet. Be sure plug ts ghtly into outlet.
Now the power pilot light will light on.
3. ON/OFF buon
Press the buon ON/OFF to start the fan
Note: the default fan speed and fan mode is Me-
dium and Normal when press ON/OFF one me.
4. SPEED buon
Press the SPEED button to set the desired fan
speed (Low/ Medium/ High).
As per the following sequence: MI HI Lo MI.
The fan speed selecng can be circulated and the
speed pilot lamp will be on during the fan operat-
ing.
5. SWING buon
If you want to enlarge blast area in your room,
press the SWING buon, the fan will blast your
room in large scope; the SWING light will be illu-
minated. To stop SWING, just press the SWING
8. COOL buon
Please noted that the COOL LAMP will flashing
when you press the Cool buon if there is no or
lacked water in water tank.
8-1 Before operang the unit in Cool mode, make
sure the escape valve for the water tank is prop-
erly xed. Then proceed to add clean water into
the water tank. While adding the water, make
sure that you keep an eye on the water level
indicator to make sure that you do not OVER or
UNDER FILL the unit. Press the buon Cool aer
you have added the water and the unit should
commence to blow cooler air. The cool light will
light on at the same time. When you press the
buon Cool again, it will stop working, the cool
light will also go out.
8-2 If you nd that the air aer Step 1) is sll not
cool enough, you can add additional ice block
into the water tank directly by opening the water
tank cover. Be sure not to exceed the icebox ca-
pacity otherwise damage to the unit or electric
shock may occur.
8-3 If you wish to use an Ice box instead of ice
block, just place it directly into the tank by open-
ing the water door. It will be good cooling effi-
ciency if you place it in your refrigerator and let
the ice pack freeze for 1 to 2 hours.
8-4 You may complete pull out water tank, then
replace water in the water tank or clean water
tank,
8-5 Under the cooling work condion, the appli-
ance will delay 5 minutes to stop working when
you shut off the unit or timing finished, during
the extended period, the timer pilot lamp is
ashed.
9. ANION buon
To gain fresh air in your room, just press ANION
buon and the build-in ionizer will operate.
10.The funcon of above item can be carried out
with your remote control by pressing the corre-
sponding function button. The buttons on the
remote control are idencal with the buons on
the control panel. The remote control can work
with a distance of within 6 meters and an angle
about 20 degrees. Furniture and other objects
between the RC sender and receiver may aect
signal transmission and reduce the range.
Insert 2 AAA batteries into the remote control
(not in scope of delivery).
12. How to knock down the dust-proof bracket
and honeycomb lter.
1) Pull out the dust-proof bracket.
2) Rotate the knobs outwards like le image.
3) Take up the honeycomb lter.
13. To turn o the unit just press the buon OFF.
14. To completely shut the unit off, turn all the
controls to OFF, and remove plug from the sock-
et-outlet.
button again, the SWING pilot light will go out.
Moving the horizontal louvers either up or down
can make further wind direcon enhancements.
6. TIMER button
Set the time by pressing the timer button to
select a desired timing level as follow, the
range is between 1-9 hours. The pilot light
corresponding to the selected timing level will
be illuminated.
7. MODE button
The default setting is Normal wind, and then
you can press the button Mode again to
choose your desired wind mode as per the
following sequence:
NORMAL NATURAL SLEEP
The wind mode selecting can be circulated
and the wind mode pilot lamp will be on
during the fan mode in operating.
12 13
1
3
2
1.Rotate the small knob updowm.
3.Add the water from here into water tank
4.Put ices into ice basket
2.Pull out the water tank
5.Put the ice box also into water tank

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Monzana DBKA002 and is the answer not in the manual?

Monzana DBKA002 Specifications

General IconGeneral
BrandMonzana
ModelDBKA002
CategoryAir Conditioner
LanguageEnglish

Related product manuals