PRODUCT INSTRUCTIONS
INSTALLATION PREPARATION
1. Determine the mounting location. Be sure that you’ll be mounting
to a secure wall or ceiling, next to a stud.
2. Complete all wire and conduit runs prior to installation of the
housing.
REVISION DATE: August 3, 2004
Depending on the voltage being used, refer to one of the formulas
below to select the correct power supply for cameras connected in
parallel (positive to positive, negative to negative):
Total current for a 12 VDC system:
TOTAL CURRENT = (350mA x total number of cameras)
Total current for a 24 VAC system:
TOTAL CURRENT = (202mA x total number of cameras)
VOLTAGE CURRENT POWER
12 VDC 350mA 4.2W
24 VAC 202mA 4.8W
CABLE AND POWER GUIDELINES
(Detailed info on Page 11)
This chart shows the proper current needed for power supplies
for Warrior Series cameras. Use Class 2 Power only. Input voltage
must be between 12-28 VDC or 15-28 VAC.
81-IN5218-06154 WARRIOR 5
WS5-XXXX
Cutout
S
T
U
D
Figure 1
Figure 2
4. Position the double-gang box in the cutout against the stud and
mark the location of the two mounting holes on the side. Remove
the double-gang box.
5. Determine which side the conduit outlet will be located on: Top,
bottom, left, right, or back. Remove the desired conduit knockout.
CAUTION: TO PREVENT DAMAGE, THE CAMERA AND
BRACKET MUST BE REMOVED BEFORE
TAKING OUT THE CONDUIT KNOCKOUT.
2. Using the security tool provided, loosen the (4) 8-32 security
fasteners and remove the face plate (Figure 2).
3. Loosen the (2) 8-32 screws holding the top of the camera bracket
and camera in place (Figure 3) and remove.
4 3/4"
4 3/4"
NOTE: The double-gang box must be fl ush with the drywall.
Two sets of mounting holes are provided on the
sides of the gang box. Use either to ensure that the
box is fl ush with the drywall.
Figure 3
INSTALLATION PROCEDURE
1. Cut a 4 3/4” x 4 3/4” square hole in the surface with one side
against the stud (Figure 1). If necessary, use the template
provided on the last page of these instructions.
TABLE OF CONTENTS
Cable and Power Guidelines 1, 11
Installation Preparation 1
Installation Procedure 1
Wiring 2
Optional Warrior Test Monitor Cable 2
Camera Bracket Setup 2
Camera Focusing 3
Camera Settings 3
Completion of Installation 5
Window Guard™ Replacement 5
NVT Instructions 5
Warranty Information 7
Service and Safeguard Information 8
Troubleshooting 9
To Next Page
Need help?
General
