Moo
Guitar Service Manual
Example
Tape protection card under bridge to protect finish incase bridge is lowered against
guitar. This will remain until final inspection.
Hardware installation:
Pull (1) of each of the following: Pot assembly, Switch assembly, XLR assembly
(see Fig. B, C, and D for pre-assembly build instructions).
inspect each of these for quality solder connections (i.e. no cold solder joints, no
ex
osed wire to risk shortin
.
inspect wiring for correct connections.
Add one rubber insulation pad on bottom of each pot housing.
Clip the locating tabs off each pot.
Depending on thickness of UI wood, place either a small lock washer or a large
lockwashe
between each of the 5
ots and the
uitar cavit
wood.
Place pots through correct panel hole so that washer allows just enough bushing
thread for one nut and washer on the outside of the guitar. If too many threads are
left, a thicker lock washer should have been used. This will be obvious once knobs
are installed and the nuts are visible underneath. Instead the knob should stop just
above the guitar surface, as seen in photo.
Continue installing all pots with lock washers, nuts, and washers. When all 5 are
installed, correct the pots' orientation and lightly tighten the nuts with a 10mm hex
driver. Their correct orientation should have all pot leads pointing in the direction
of the pick up cavities. Please be cautious not to over tighten. This will cause the
finish to se
arate from the wood.
To Next Page
Loading...